Manufacturing Capabilities
Five capabilities run under one engineering review. Each page lists the specification, the process limits, and — equally important — the cases where you should use a different process instead.
Our capabilities are 3-, 4- and 5-axis CNC milling, CNC turning with live tooling, tight-tolerance machining of critical features, DFM and NPI support, and inspection and documentation. We target ±0.05 mm on general dimensions with tighter bands on critical features confirmed by first-article inspection. Forging, casting, heat treatment, welding and grinding are subcontracted to audited suppliers and remain under our incoming-inspection gate; we do not claim management-system certifications we do not hold.
CNC Milling (3/4/5-Axis)
CNC milling from 3-axis to simultaneous 5-axis for complex prismatic parts. Single-setup machining to control tolerance stack-up, DFM review included.
Specification and process limitsCNC Turning
CNC turning for shafts, pins, fittings and threaded parts with live tooling for cross-drilling and milling in one setup, from prototype to small batch.
Specification and process limitsTight-Tolerance Machining
Tight-tolerance machining of critical features in hardened and specialty alloys, with datum control, single-setup finishing and first-article verification.
Specification and process limitsDFM & NPI Support
DFM review and NPI support: written feedback before every quote, prototype to small-batch transition, and changes tracked by revision.
Specification and process limitsInspection & Documentation
First-article inspection, material certificates, dimensional reports and traceability for machined parts — the records that defend a part in an audit.
Specification and process limitsTolerance and suitability by process
The same feature can often be produced more than one way at different price points. This table shows the bands we target and the quantity ranges where each process makes sense.
| Process | Typical tolerance | Surface finish | Economical quantity | Lead time |
|---|---|---|---|---|
| 3-axis milling | ±0.05 mm general | Ra 1.6 µm standard | 1 – 10,000 | Per quote |
| 5-axis milling | Tighter on critical features, confirmed by FAI | Ra 0.4 µm achievable | Prototype – mid batch | Per quote |
| CNC turning | ±0.05 mm on diameter; tighter by FAI | Ra 0.4 µm achievable | 1 – 10,000 | Per quote |
| Surface treatment | Adds coating thickness; allowance at DFM | Per specification | Any | Subcontracted |
Surface treatment changes dimensions: coating thickness is added to the part, so bores, threads and press fits must be specified with finish allowance in the drawing. This is decided at DFM, not after machining.
Send drawings, get a review and a quote
Send a STEP file and a 2D drawing. You get a fixed-price quotation with lead time and a written DFM note — no obligation, and no sales call unless you ask for one.